Engineer Live RSS Feed http://www.engineerlive.com Engineer Live RSS Feed en-us http://www.engineerlive.com 2007-02-01T::00+00:00 hourly 1 2007-02-01T12:00+00:00 Bearings to provide greater load-carrying capacity http://www.engineerlive.com/Design-Engineer/Power_Transmission/Bearings_to_provide_greater_load-carrying_capacity/22465/ 16/03/2010 Thermocouple is suitable for measuring very high temperatures http://www.engineerlive.com/Process-Engineer/Instrumentation/Thermocouple_is_suitable_for_measuring_very_high_temperatures/22405/ 15/02/2010 Pilot-operated servo proportional valves use voice coil technology http://www.engineerlive.com/Process-Engineer/Process_Equipment/Pilot-operated_servo_proportional_valves_use_voice_coil_technology/22450/ 09/03/2010 Jet valves switch ten times faster than solenoid valves http://www.engineerlive.com/Process-Engineer/Process_Equipment/Jet_valves_switch_ten_times_faster_than_solenoid_valves___/22479/ 16/03/2010 Making rapid prototyping pay dividends in full http://www.engineerlive.com/Design-Engineer/Computer_Systems_Software/Making_rapid_prototyping_pay_dividends_in_full/22476/ 16/03/2010 Magnetostrictive linear transducers are immune to noise http://www.engineerlive.com/Design-Engineer/Power_Transmission/Magnetostrictive_linear_transducers_are_immune_to_noise/22477/ 16/03/2010 Report identifies market potential for automation in food industry http://www.engineerlive.com/Process-Engineer/Automation_Control/Report_identifies_market_potential_for_automation_in_food_industry/22482/ 16/03/2010 ISO brochure: international standards and private standards http://www.engineerlive.com/Design-Engineer/Interview_Opinion/ISO_brochure%3A_international_standards_and_private_standards/22478/ 16/03/2010 How manufacturers can prepare for post-recession profitability http://www.engineerlive.com/Design-Engineer/Interview_Opinion/How_manufacturers_can_prepare_for_post-recession_profitability/22454/ 16/03/2010 Pinion shafts can meet special requirements http://www.engineerlive.com/Design-Engineer/Motors_and_Drives/Pinion_shafts_can_meet_special_requirements/22471/ 16/03/2010 Scratch prevention coating http://www.engineerlive.com/Design-Engineer/Automotive_Design/Scratch_prevention_coating/22456/ 16/03/2010 Worm-type gear is low-cost alternative to conventional designs http://www.engineerlive.com/Design-Engineer/Power_Transmission/Worm-type_gear_is_low-cost_alternative_to_conventional_designs__/22398/ 15/02/2010